WS2811 LED Pixel Strip 0.5m, 30/m

$8.99  $7.64
Save: 15% off

Sold Out


Quantity Discounts
1
$7.64
2-3
$6.88
4-7
$6.11
8+
$5.35

These LED strips have 30 individually controllable super-bright LEDs per meter, and we're selling these by the half-meter. They're a convenient way to get a lot of RGB pixels glowing with minimal wiring and cost. Strips can be cut with scissors at every single LED...this means you can cut each half-meter strip into 15 independent pixels, or to the exact length required by your project. Only three wires run through each strip: power, ground, and data.

Each LED has its own controller chip, embedded inside the LED itself. The red, green, and blue elements of each LED can be set to individual brightnesses of 0 to 255 PWM counts, corresponding to 0% to 100% brightness. This means each pixel is capable of 24-bit color.

Controlling the LEDs is fairly timing-intensive. If you are using an Arduino, you will need to use one of the available WS2811 libraries that have an assembly language driver for the LEDs. Faster controllers will likely have fewer problems, as long as reliable sub-microsecond I/O timing is possible.

Your order will be delivered in one continuous length up to 5 meters; 5 meter increments will be delivered on a spool. Sections of 1/2 meter are lap-soldered, which may offset the pixel spacing by small amounts along the strip.

Specifications:
Pixels per meter: 30 RGB 5050
PWM bit depth: 8 bits per color, 24 bits total
Mask color: black
Pixel pitch:33.33mm or 1.312 inches
Power: 5V, max 0.9A per 1/2 meter
Waterproof covering: no
Adhesive backing: yes


  • Model: MTPIX003
  • 0 Units in Stock


Your IP Address is: 54.226.113.250
Copyright © 2017 macetech LLC. Powered by Zen Cart